Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 180 (SIDE AND REAR VISION)REMOVAL AND INSTALLATIONSIDE OBSTACLE DETECTION CONTROL MODULEREMOVAL
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Side Obstacle Detection Control Module: Removal
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Removal
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: If installing a new side obstacle detection (SOD) control module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new SOD control module after installation
Using a diagnostic scan tool, begin the PMI process for the side obstacle detection (SOD) control module following the on-screen instructions.
- Remove the rear lamp assembly. Refer to: Rear Lamp Assembly .
- Remove the screws and the side obstacle detection (SOD) control module assembly.
- Remove the screws, disconnect the electrical connector and remove the side obstacle detection (SOD) control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.