Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 180 (SIDE AND REAR VISION)
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Section 180 (Side And Rear Vision)
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Section 180 (Side And Rear Vision)
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Blind Spot Information System
- DTC Chart(s)
- Symptom Chart(s)
- Pinpoint Tests
- Pinpoint Test A : The BLIS (Blind Spot Information System) ® Is Inoperative Or Does Not Function Correctly
- Pinpoint Test B : The CTA (Cross Traffic Alert) System Is Inoperative Or Does Not Function Correctly
- Pinpoint Test C : An Exterior Mirror BLIS (Blind Spot Information System) ®/ CTA (Cross Traffic Alert) Led (Light Emitting Diode) Is Always On
- Pinpoint Test D : An Exterior Mirror BLIS (Blind Spot Information System) ®/ CTA (Cross Traffic Alert) Led (Light Emitting Diode) Is Inoperative
- Pinpoint Test E : The IPC (Instrument Panel Cluster) Message Center Displays A Blocked Sensor Message
- Pinpoint Test F : The BLIS (Blind Spot Information System) ® And CTA (Cross Traffic Alert) System Cannot Be Turned Off In The Message Center
- Pinpoint Test G : U0100:00
- Pinpoint Test H : U0146:00
- Pinpoint Test I : DTC (Diagnostic Trouble Code) U0199:00
- Pinpoint Test J : DTC (Diagnostic Trouble Code) U0200:00
- Blind Spot Information System
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.