Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0141 - O2 Sensor Heater Circuit (Bank 1 Sensor 2)
2021 Ford Edge SE, 4WDSECTION DTC P0141 - O2 Sensor Heater Circuit (Bank 1 Sensor 2)
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2020 Lincoln Navigator, 2020 Lincoln Nautilus, 2020 Lincoln MKZ, 2020 Lincoln Corsair, and 2020 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P0141 - O2 SENSOR HEATER CIRCUIT (BANK 1 SENSOR 2)
| Description: | This DTC sets when an open or short circuit is detected or the heated oxygen sensor bank 1, sensor 2 (HO2S12) heater current draw exceeds a calibrated limit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Inspect the connectors for signs of damage, water intrusion or corrosion. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DW . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.