SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 744 (ENGINE CONTROLS - POWERTRAIN DTC DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0001 - P0238)DTC P0130 - O2 SENSOR CIRCUIT (BANK 1 SENSOR 1)
2021 Ford Edge SE, 4WD

DTC P0130 - O2 Sensor Circuit (Bank 1 Sensor 1)

2021 Ford Edge SE, 4WDSECTION DTC P0130 - O2 Sensor Circuit (Bank 1 Sensor 1)
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2020 Lincoln Navigator, 2020 Lincoln Nautilus, 2020 Lincoln MKZ, 2020 Lincoln Corsair, and 2020 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P0130 - O2 SENSOR CIRCUIT (BANK 1 SENSOR 1)

Description:  This DTC sets when a concern is detected with one of the circuits used to determine the oxygen content in the exhaust gas.
Possible Causes: 
  • UO2S11 circuit open (if equipped)
  • UO2S11 circuit short to ground (if equipped)
  • UO2S11 circuit short to voltage (if equipped)
  • UO2SGREF11 circuit open (if equipped)
  • UO2SGREF11 circuit short to ground (if equipped)
  • UO2SGREF11 circuit short to voltage (if equipped)
  • UO2SPC11 circuit short to ground (if equipped)
  • UO2SPC11 circuit short to voltage (if equipped)
  • UO2SPCT11 circuit short to ground (if equipped)
  • UO2SPCT11 circuit short to voltage (if equipped)
  • HO2S11 circuit open (if equipped)
  • HO2S11 circuit short to ground (if equipped)
  • HO2S11 circuit short to voltage (if equipped)
  • Incorrect connections
  • Damaged or corroded pins
  • Exhaust temperature significantly higher than expected
  • Damaged universal heated oxygen sensor bank 1, sensor 1 (HO2S11) (if equipped)
  • Damaged HO2S11 (if equipped)
Diagnostic Aids:  Inspect the connectors for signs of damage, water intrusion or corrosion.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
EcoSport 1.5L, GO to PINPOINT TEST DW .
KA  
All others GO to PINPOINT TEST DZ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.