Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 662 (STARTING SYSTEM - 3.5L V6 POWERBOOST (CN))
2021 Ford Edge SE, 4WD
Section 662 (Starting System - 3.5L V6 POWERBOOST (CN))
2021 Ford Edge SE, 4WDSECTION Section 662 (Starting System - 3.5L V6 POWERBOOST (CN))
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Starting System - Overview
- Starting System - System Operation and Component Description
- Starting System - Component Location
- Diagnosis And Testing
- Starting System
- Diagnostic Trouble Code (DTC) Chart
- Global Customer Symptom Code (GCSC) Chart
- Symptom Chart(s)
- Pinpoint Test(s)
- Pinpoint Test A: Engine Does Not Crank - Without Push-Button Start
- Pinpoint Test B: Engine Does Not Crank - With Push-Button Start
- Pinpoint Test C: Unusual Starter Noise
- Pinpoint Test D: C113A:11, C113A:15
- Pinpoint Test E: DTC P06EF Degraded Crank
- Pinpoint Test F: DTC U0120
- Pinpoint Test G: BISG Failure
- Pinpoint Test H: Battery Isolation / Voltage Control Circuit
- Pinpoint Test I: Battery Isolation/Voltage Stabilization Control Circuit Performance
- Pinpoint Test J: Battery Isolation/Voltage Control Circuit Low
- Pinpoint Test K: Battery Isolation / Voltage Control Circuit High
- Pinpoint Test L: DTC U041A, U061E
- Pinpoint Test M: B15DB:09
- Pinpoint Test N: DTC P06E4
- Pinpoint Test O: DTC P162F
- Pinpoint Test P: The Engine Cranks Slowly
- Pinpoint Test Q: The Starter Spins But The Engine Does Not Crank
- Pinpoint Test R: The Starter Does Not Disengage From The FLEXPLATE
- Pinpoint Test S: Auto-Start-Stop System Is Inoperative Or Does Not Operate Correctly
- Pinpoint Test T: Auto-Start-Stop System Cannot Be Disabled By Driver
- Starting System
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.