Pinpoint Test Y: U0419:86

2021 Ford Edge SE, 4WDSECTION Pinpoint Test Y: U0419:86
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    REFER to: Lane Keeping System - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    IPMA U0419:86 Invalid Data Received From Steering Effort Control Module: Signal Invalid This DTC sets when the IPMA receives invalid network data from the SCCM with a faulted cruise control switch input.

    Possible Sources 

    • Steering effort control module concern
    • SCCM concern

  2. Y1 CHECK FOR STEERING COLUMN CONTROL MODULE SIGNAL

    • Ignition ON.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.

    Is DTC U0419:86 still present? 

    Yes  RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network REFER to: Steering Wheel and Column Electrical Components .
    No  The repair is complete.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.