Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Bn: U3000:89
2021 Ford Edge SE, 4WDSECTION Pinpoint Test Bn: U3000:89
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Lane Keeping System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U3000:89 Control Module: Data Transfer Failure This continuous memory and on-demand DTC sets in IPMA when data transfer failure from IPMA. Possible Sources
- Communication network concern
- IPMA
- BN1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using the diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Wait 10 seconds.
- Using the diagnostic scan tool, carry out the IPMA self-test.
Is DTC U3000:89 retrieved?
Yes INSTALL a new suspect module. Refer concern section for module progamming. No The system is operating correctly at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.