Pinpoint Test BH: B1385:82

2021 Ford Edge SE, 4WDSECTION Pinpoint Test BH: B1385:82
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    REFER to: Lane Keeping System - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    IPMA B1385:82 Lane Keeping Aid System: Alive/Sequence Counter Incorrect/Not Updated This continuous memory DTC can set due to a fault in the IPMA or an error in the IPMA.

    Possible Sources 

    • Suspect module
    • IPMA

  2. BH1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE MODULE SENDING INVALID DATA

    • Ignition ON.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.

    Is DTC U3185:82 still present? 

    Yes  RETRIEVE and FOLLOW non-network Diagnostic Trouble Codes (DTCs) from the IPMA. REFER to: Controller Area Network (CAN) Module Communications Network . REFER to: Ethernet Module Communications Network .
    No  DIAGNOSE the observable symptom present. REFER to the Symptom Chart(s) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.