Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Ac: U0452:86
2021 Ford Edge SE, 4WDSECTION Pinpoint Test Ac: U0452:86
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Lane Keeping System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U0452:86 Invalid Data Received From Restraints Control Module: Signal Invalid This continuous memory DTC can set in IPMA due to a fault in the RCM or an invalid input from the RCM Possible Sources
- RCM concern
- AC1 CHECK FOR RCM (RESTRAINTS CONTROL MODULE) SIGNAL
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.
Is DTC U0452:86 still present?
Yes RETRIEVE and FOLLOW non-network Diagnostic Trouble Codes (DTCs) from the RCM REFER to: Airbag Supplemental Restraint System (SRS) . No DIAGNOSE the observable symptom.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.