SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P2610 - ECM/PCM ENGINE OFF TIMER PERFORMANCE
2021 Ford Edge SE, 4WD

DTC P2610 - ECM/Pcm Engine Off Timer Performance

2021 Ford Edge SE, 4WDSECTION DTC P2610 - ECM/Pcm Engine Off Timer Performance
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2018 Lincoln Navigator, 2018 Lincoln MKZ, 2018 Lincoln MKX, 2018 Lincoln MKT, and 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
P2610 - ECM/PCM ENGINE OFF TIMER PERFORMANCE

Description:  This DTC sets when the difference between the engine off time and the central processing unit (CPU) time exceeds a calibrated limit for a calibrated amount of time.
Possible Causes: 
  • Incorrect or intermittent battery cable connections
  • KAPWR circuit to PCM concern
  • Engine coolant temperature (ECT) sensor concern
  • Engine cooling system concerns
  • Engine stall
  • Rapid ignition key cycle
  • Module communications network concerns
Diagnostic Aids:  This DTC may set with other DTCs. Check for all other DTCs and diagnose those first. If DTC P2610 sets after a module programming, disregard this DTC. Clear the DTCs and repeat the PCM self-test.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST QB .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.