SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0322 - IGNITION/DISTRIBUTOR ENGINE SPEED INPUT CIRCUIT NO SIGNAL
2021 Ford Edge SE, 4WD

DTC P0322 - Ignition/Distributor Engine Speed Input Circuit No Signal

2021 Ford Edge SE, 4WDSECTION DTC P0322 - Ignition/Distributor Engine Speed Input Circuit No Signal
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2018 Lincoln Navigator, 2018 Lincoln MKZ, 2018 Lincoln MKX, 2018 Lincoln MKT, and 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
P0322 - IGNITION/DISTRIBUTOR ENGINE SPEED INPUT CIRCUIT NO SIGNAL

Description:  This DTC sets when the crankshaft position (CKP) sensor profile ignition pickup (PIP) pulse is missing for greater than a calibrated number of camshaft revolutions when the camshaft speed exceeds the equivalent speed of engine idle.
Possible Causes: 
  • CKP+ circuit intermittent open (VR type)
  • CKP- circuit open (VR type)
  • CKP circuit open (Hall effect)
  • VREF circuit open (Hall effect)
  • SIGRTN circuit open (Hall effect)
  • CKP+ circuit short to voltage (VR type)
  • CKP- circuit short to voltage (VR type)
  • CKP circuit short to voltage (Hall effect)
  • VREF circuit short to voltage (Hall effect)
  • SIGRTN circuit short to voltage (Hall effect)
  • CKP+ circuit short to ground (VR type)
  • CKP- circuit short to ground (VR type)
  • CKP circuit short to ground (Hall effect)
  • VREF circuit short to ground (Hall effect)
  • SIGRTN circuit short to ground (Hall effect)
  • Damaged CKP sensor
  • CKP sensor incorrectly installed
  • Incorrect, damaged or corroded connections
Diagnostic Aids:  An inactive CKP signal causes a no start condition. Monitor the RPM PID while cranking the engine. A value of 0 RPM indicates a CKP concern.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST A .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.