Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P064E - INTERNAL CONTROL MODULE O2 SENSOR PROCESSOR PERFORMANCE (BANK 2)
2021 Ford Edge SE, 4WD
DTC P064E - Internal Control Module O2 Sensor Processor Performance (Bank 2)
2021 Ford Edge SE, 4WDSECTION DTC P064E - Internal Control Module O2 Sensor Processor Performance (Bank 2)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2018 Lincoln Navigator, 2018 Lincoln MKZ, 2018 Lincoln MKX, 2018 Lincoln MKT, and 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
P064E - INTERNAL CONTROL MODULE O2 SENSOR PROCESSOR PERFORMANCE (BANK 2)
| Description: | The PCM monitors the application specific integrated circuit that controls and monitors the universal heated oxygen sensor bank 2, sensor 1 (HO2S21). This DTC sets when the PCM detects an internal circuit or communication concern. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check for other DTCs and diagnose those first. Check for intermittent universal HO2S wiring concerns. Check the universal HO2S wiring between the PCM and the sensor for damage. Check for aftermarket performance products. Reprogram or update the calibration. Clear the DTCs, repeat the self-test. If the DTC is retrieved again, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.