Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Motor Electronics Cooling System (MECS) Pump
The motor electronics cooling system is required to maintain an acceptable operating temperature for the TCM. The TCM commands the MECS pump and operation using the MECSP circuit. The pump (located near the radiator) receives the MECSP command. The MECS pump is commanded on for a calibrated time when the vehicle is first started to degas the MECS system. The coolant in the system flows in a loop from the MECS pump, to the TCM, and then into the MECS radiator bottom hose port, out of the top hose port of the MECS radiator, and back into the MECS pump. The cooling system has a degassing system that is connected in parallel between the MECS radiator and the MECS pump. The degassing system bleeds air or gases into the degas reservoir.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.