Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mass Airflow (MAF) Sensor
The MAF sensor provides a signal to the PCM proportional to the intake air mass. The MAF sensor uses a hot wire sensing element to measure the amount of air entering the engine. The hot wire is maintained at a constant temperature above ambient. Air passing over the hot wire cools the wire. The current required to maintain the temperature of the hot wire is proportional to the airflow. The PCM calculates the required fuel injector pulse width in order to provide the desired air to fuel ratio.
The MAF sensor is a digital sensor that provides an output signal of varying frequency. The signals time period is proportional to the flow rate crossing the sensor. The greater the airflow the shorter the time period.
The time period varies from 1480 microseconds at a low flow or idle condition, to 106 microseconds at a high flow rate condition.
The MAF/IAT sensor is located in the intake air tube between the air filter housing and the throttle body.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.