Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014MUSTANG GT, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDRIVESHAFT & UNIVERSAL JOINTSDRIVELINE SYSTEM - GENERAL INFORMATIONGENERAL PROCEDURESDRIVELINE ANGLE MEASUREMENT
2014 Ford Mustang GT, 2D Coupe, Automatic Trans
Driveline Angle Measurement
2014 Ford Mustang GT, 2D Coupe, Automatic TransSECTION Driveline Angle Measurement
SPECIAL TOOL DESCRIPTION
| Anglemaster II Driveline Inclinometer/Protractor 164-R2402 or equivalent |
NOTE:
This procedure does not apply to CV joints, flex couplers or double cardan joints that are used in some driveshafts. This check is for single-cross and roller-style joints found in the driveshafts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.