P061B: Internal Control Module Torque Calculation Performance

2014 Ford F-450 Super Duty Platinum, RWDSECTION P061B: Internal Control Module Torque Calculation Performance
P061B - INTERNAL CONTROL MODULE TORQUE CALCULATION PERFORMANCE

Description:  This DTC sets when a calculation error occurred in the PCM.
Possible Causes: 
  • Aftermarket performance products
  • PCM programming error
Diagnostic Aids:  Check for sensor and circuit related DTCs.
Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.