Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-450 SUPER DUTY PLATINUM, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL)DTC DIAGNOSISP060B: INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
2014 Ford F-450 Super Duty Platinum, RWD
P060B: Internal Control Module A/D Processing Performance
2014 Ford F-450 Super Duty Platinum, RWDSECTION P060B: Internal Control Module A/D Processing Performance
P060B - INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
| Description: This DTC sets when an error occurs in the PCM. | |||
Possible Causes:
|
|||
| Diagnostic Aids:
Verify the PCM is at the latest calibration level. Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a replacement PCM. |
|||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.