Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2011ESCAPE 4WD L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMEEXTERIOR MOULDING / TRIMCOWL MOULDING / TRIMSERVICE AND REPAIR
2011 Ford Escape 4WD L4-2.5L
Cowl Moulding / Trim: Service and Repair
2011 Ford Escape 4WD L4-2.5LSECTION Service and Repair
Cowl Panel Grille
Removal and Installation
1. Remove the 2 wiper pivot arms nuts.
- To install, tighten to 35 Nm (26 lb-ft).
2. Remove the LH and RH wiper pivot arms.
3. Remove the LH and RH cowl end cap pushpin retainers.
4. Remove the cowl end caps.
5. Release the cowl panel grille from the retaining clips and remove the cowl panel grille.
6. To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to Wipers and Washers Wiper Blade and Pivot Arm Adjustment - Windshield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.