SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010CROWN VICTORIA V8-4.6L FLEX FUELREPAIR AND DIAGNOSISSTARTING AND CHARGINGSENSORS AND SWITCHES - STARTING AND CHARGINGIGNITION SWITCHSERVICE AND REPAIR
2010 Ford Crown Victoria V8-4.6L Flex Fuel

Ignition Switch: Service and Repair

2010 Ford Crown Victoria V8-4.6L Flex FuelSECTION Service and Repair



Ignition Switch

Removal and Installation

NOTE: Steering wheel removed for clarity.











1. Depower the Supplemental Restraint System (SRS) For additional information, refer to Restraint Systems.

2. Remove the steering column tilt release lever/handle.





3. NOTE: Release the upper steering column shroud by pressing the sides inward.

Remove the 3 screws and the upper and lower steering column shrouds.

- To install, tighten to 2 Nm (18 lb-in).

4. Remove the ignition switch.

1. Disconnect the electrical connector.

2. Remove the ignition switch screw and remove the ignition switch.
- To install, tighten to 5 Nm (44 lb-in).

5. To install, reverse the removal procedure.

6. Repower the SRS. For additional information, refer to Restraint Systems.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.