Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010CROWN VICTORIA V8-4.6L FLEX FUELREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSNORMAL SERVICE30000 MI OR 48000 KM
2010 Ford Crown Victoria V8-4.6L Flex Fuel
30000 MI or 48000 KM
2010 Ford Crown Victoria V8-4.6L Flex FuelSECTION 30000 MI or 48000 KM
Inspect
Wheels
Inspect the wheels and related components for abnormal noise, wear, looseness, or drag.
Vehicle
Recommended Multi-point Inspection
Universal Joint, Drive/Propeller Shaft
If equipped.
Tie Rod End
Inspect tie rod ends (lubricate if equipped with Zerk fittings)
Steering and Suspension
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
Fluid - A/T
Inspect automatic transmission fluid level (if equipped with an underhood dipstick).
Exhaust System
Inspect exhaust system and heat shields.
Cooling System
Every 15,000 miles (24,000 km), 600 hours of engine operation or as indicated by the instrument cluster message center
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system.
Ball Joint
If equipped.
Replace
Oil Filter, Engine
Fuel Filter
Replace fuel filter.
Filters
Climate-controlled seat filter
Engine Oil
Change engine oil and filter.
Air Filter Element
Replace engine air filter.
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
Wheels
Inspect the wheels and related components for abnormal noise, wear, looseness, or drag.
Vehicle
Recommended Multi-point Inspection
Universal Joint, Drive/Propeller Shaft
If equipped.
Tie Rod End
Inspect tie rod ends (lubricate if equipped with Zerk fittings)
Steering and Suspension
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
Fluid - A/T
Inspect automatic transmission fluid level (if equipped with an underhood dipstick).
Exhaust System
Inspect exhaust system and heat shields.
Cooling System
Every 15,000 miles (24,000 km), 600 hours of engine operation or as indicated by the instrument cluster message center
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system.
Ball Joint
If equipped.
Replace
Oil Filter, Engine
Fuel Filter
Replace fuel filter.
Filters
Climate-controlled seat filter
Engine Oil
Change engine oil and filter.
Air Filter Element
Replace engine air filter.
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.