Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONNOISE, VIBRATION AND HARSHNESSGENERAL PROCEDURESPOWERTRAIN/DRIVETRAIN MOUNT NEUTRALIZING
2007 Ford Focus SES, 4D Sedan, Standard
Powertrain/Drivetrain Mount Neutralizing
2007 Ford Focus SES, 4D Sedan, StandardSECTION Powertrain/Drivetrain Mount Neutralizing
NOTE:
There is no procedure for neutralizing the powertrain/drivetrain mounts. To check the alignment of the powertrain mounts visually, proceed as follows.
- Loosen the rear support insulator.
- Loosen the powertrain/drivetrain mounts.
- Support the powertrain/drivetrain in an approximate position and height, so that the right-hand mount and left-hand insulator align over the studs on the powertrain and drivetrain to allow the fixings to be assembled through the large holes in the bracket support insulator without overstraining.
- Tighten the fixings to the powertrain/drivetrain.
- Tighten the body side fixings.
- Tighten the rear support insulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.