Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONNOISE, VIBRATION AND HARSHNESS
2007 Ford Focus SES, 4D Sedan, Standard
Noise, Vibration And Harshness
2007 Ford Focus SES, 4D Sedan, StandardSECTION Noise, Vibration And Harshness
- Description And Operation
- Diagnostic Tests
- Noise, Vibration and Harshness (NVH)
- Notes
- 1: Customer Interview
- 2: Pre-Drive Check
- 3: Preparing for the Road Test
- 4: Verify the Customer Concern
- 5: Road Test
- 6: Check OASIS/TSBs/Repair History
- 7: Diagnostic Procedure
- NVH Condition and Symptom Categories
- Symptom Charts
- Pinpoint Tests
- Notes
- Pinpoint Test A: Brake Vibration/Shudder
- Pinpoint Test B: Engine Ticking Noise
- Pinpoint Test C: Accessory Drive Bearing Hoot
- Pinpoint Test D: Power Steering Moan
- Pinpoint Test E: Engine Driven Cooling Fan Moan
- Pinpoint Test F: Drumming Noise
- Pinpoint Test G: Engine Ticking, Knocking Or Continuous Rattle Diagnosis
- Pinpoint Test H: Front Suspension Noise
- Pinpoint Test I: Rear Suspension Noise
- Pinpoint Test J: Wheel And Tire Vibration
- Pinpoint Test K: High Speed Shake Or Shimmy
- Pinpoint Test L: Clutch Vibration
- Component Tests
- Noise, Vibration and Harshness (NVH)
- General Procedures
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.