Electronic Automatic Temperature Control (EATC) Module Diagnostic Trouble Code (DTC) Index

2007 Ford Focus SES, 4D Sedan, StandardSECTION Electronic Automatic Temperature Control (EATC) Module Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
ELECTRONIC AUTOMATIC TEMPERATURE CONTROL (EATC) MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC EATC (On Demand) Self-Test Faults EATC (Continuous) Run-Time Faults Description Action to Take
B2266 024 025 Blend door failure or short GO to PINPOINT TEST AΒ .
B1251 031 N/A A/C in-car temperature sensor open circuit GO to PINPOINT TEST BΒ .
B1253 030 N/A A/C in-car temperature sensor short to ground GO to PINPOINT TEST BΒ .
B1255 041 043 A/C ambient temperature sensor open circuit GO to PINPOINT TEST CΒ .
B1257 040 042 A/C ambient temperature sensor short to ground GO to PINPOINT TEST CΒ .
B1259 N/A N/A A/C solar radiation sensor circuit open GO to PINPOINT TEST DΒ .
B1261 050 052 A/C solar radiation sensor circuit short to ground GO to PINPOINT TEST DΒ .
U1073 N/A - SCP invalid or missing data for engine coolant See INTRODUCTION - GASOLINE article or INTRODUCTION -- 6.0L DIESEL article .
U1341 N/A N/A SCP invalid data for vehicle speed See INTRODUCTION - GASOLINE article or INTRODUCTION -- 6.0L DIESEL article .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.