Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005PICKUP F250 SUPER DUTY, 2D PICKUP, 5.4 5, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTION (EXCEPT DIESEL & HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P060B: INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
2005 Ford Pickup F250 Super Duty, 2D Pickup, 5.4 5, 4WD, Automatic
DTC P060B: Internal Control Module A/D Processing Performance
2005 Ford Pickup F250 Super Duty, 2D Pickup, 5.4 5, 4WD, AutomaticSECTION DTC P060B: Internal Control Module A/D Processing Performance
P060B - INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
| Description: | Indicates an error occurred in the powertrain control module (PCM). This DTC is set in combination with P2104 or P2110. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Do not install a new PCM until the following steps are completed. Inspect the harness for damage. Verify correct operation of the sensors using VREF and related circuits. GO to Pinpoint Test C . If the concern or DTC is still present, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.