Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005PICKUP F250 SUPER DUTY, 2D PICKUP, 5.4 5, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST HG: POSITIVE CRANKCASE VENTILATION (PCV) SYSTEM THROUGH PINPOINT TEST JD: CRANKSHAFT POSITION (CKP) SENSOR - (EXCEPT DIESEL & HYBRID)PINPOINT TEST HH: EXHAUST GAS RECIRCULATION SYSTEM MODULE (ESM)NOTES
2005 Ford Pickup F250 Super Duty, 2D Pickup, 5.4 5, 4WD, Automatic
Pinpoint Test HH: Exhaust Gas Recirculation System Module (ESM): Notes
2005 Ford Pickup F250 Super Duty, 2D Pickup, 5.4 5, 4WD, AutomaticSECTION Notes
NOTE:
Proceed to DTC testing steps listed in FAULT CODE SETTING CONDITION table of fault code setting condition.
FAULT CODE SETTING CONDITION
| Fault Code | Application | Setting Condition | Testing |
|---|---|---|---|
| P0402 | Vehicles with EGR system (ESM) | KOER, Continuous Memory | HH11 |
| P0402 | All others | KOER, Continuous Memory | PINPOINT TEST HE STEP 12 |
| P0403, P1409 | Vehicles with EGR system module (ESM) | KOEO, KOER, Continuous Memory | HH21 |
| P0403 | Vehicles with electric EGR (EEGR) | KOEO, KOER, Continuous Memory | PINPOINT TEST KD STEP 1 |
| P0403, P1409 | All others | KOEO, KOER | PINPOINT TEST HE STEP 59 |
| P0403, P1409 | All others | Continuous Memory | PINPOINT TEST HE STEP 64 |
| P1400 | Vehicles with an EGR system module (ESM) | KOEO, KOER, Continuous Memory | HH1 |
| P1400 | All others | KOEO, KOER, Continuous Memory | PINPOINT TEST HE STEP 1 |
| P1401 | Vehicles with an EGR system module (ESM) | KOEO, KOER, Continuous Memory | HH4 |
| P1401 | All others | KOEO, KOER, Continuous Memory | PINPOINT TEST HE STEP 5 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.