Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake Pedal Switch (BPS)/Brake Deactivator Switch
The BPS, also sometimes called the brake deactivator switch, is for vehicle speed control deactivation. A normally closed switch supplies battery positive voltage (B+) to the PCM when the brake pedal is NOT applied. When the brake pedal is applied, the normally closed switch opens and power is removed from the PCM.
On some applications the normally closed BPS, along with the normally open brake pedal position (BPP) switch, are used for a brake rationality test within the PCM. The PCM misfire monitor profile learn function can be disable if a brake switch failure occurs. If one or both brake pedal inputs to the PCM did not change states when they were expected to, a diagnostic trouble code P1572 can be set by the PCM strategy.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.