SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CUTAWAY 5.4 L, 5R110WREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - 5R110WIN-VEHICLE REPAIRSOLENOID BODY ASSEMBLYINSTALLATION
2005 Ford Cutaway 5.4 L, 5R110W

Solenoid Body Assembly: Installation

2005 Ford Cutaway 5.4 L, 5R110WSECTION Installation
  1. Install a new solenoid body gasket.
    Fig 1: View Of Solenoid Body Gasket
    G03889054Courtesy of FORD MOTOR CO.
  2. Using the special tools, install the solenoid body and loosely install the bolts.
    • While installing the solenoid body, align the manual valve.
      Fig 2: Aligning Manual Valve
      G03889056Courtesy of FORD MOTOR CO.

  3. Tighten all the bolts in the sequence shown in Fig 3.
    Fig 3: Tightening All Bolts
    G03889057Courtesy of FORD MOTOR CO.
  4. Connect the transmission range sensor connector.
    Fig 4: Connecting Transmission Range Sensor Connector
    G03889058Courtesy of FORD MOTOR CO.
  5. Install the transmission fluid filter, pan gasket and pan.
  6. Connect the solenoid body electrical connector.
    Fig 5: Installing Solenoid Body Electrical Connector
    G03889059Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.