Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2005CUTAWAY 5.4 L, 5R110WREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - 5R110WIN-VEHICLE REPAIROUTPUT SHAFT SPEED (OSS) SENSORREMOVAL

2005 Ford Cutaway 5.4 L, 5R110W

Output Shaft Speed (OSS) Sensor: Removal

2005 Ford Cutaway 5.4 L, 5R110WSECTION Removal

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the output shaft speed (OSS) sensor.

Fig 1: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.

NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of debris to prevent contamination of the transmission.

Remove the output shaft speed (OSS) sensor.
1. Remove the bolt.
2. Remove the output shaft speed (OSS) sensor.
  
  Fig 2: Removing Output Shaft Speed (OSS) Sensor
  Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.