Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005CUTAWAY 5.4 L, 5R110WREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - 5R110WIN-VEHICLE REPAIRLINE PRESSURE CONTROL SOLENOID - PC-AINSTALLATION
2005 Ford Cutaway 5.4 L, 5R110W
Line Pressure Control Solenoid - Pc-A: Installation
2005 Ford Cutaway 5.4 L, 5R110WSECTION Installation
- Assemble the main control valve body.
- Install the pressure control solenoid (PC-A) and install the (E) retaining clip.
- Push the bulkhead connector through the solenoid body and twist the bulkhead connector locking it into place
- Install the shift solenoid (SSPC-C) back into place and install the (E) retaining clip.
- Connect the electrical connectors to the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C).
- Install the wire harness to solenoid body and tighten the bolts.
- Remove the solenoid body electrical connector O-ring seal.
- Install the transmission main control valve body. For additional information, refer to SOLENOID BODY ASSEMBLY .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.