SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2004ECONOLINE E150, VAN CARGO, 4.6 WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 259 (ANTI-LOCK BRAKE SYSTEM - ANTI-LOCK CONTROL - 4-WHEEL)REMOVAL AND INSTALLATIONMODULE - ANTI-LOCK BRAKE CONTROLREMOVAL
2004 Ford Econoline E150, Van Cargo, 4.6 W

Module - Anti-Lock Brake Control: Removal

2004 Ford Econoline E150, Van Cargo, 4.6 WSECTION Removal
WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The ABS module mounts to the HCU on a bracket on L/H inner fender well in engine compartment.
  1. Remove the hydraulic control unit (HCU).
  2. Detach the bracket from the HCU.
    1. Remove the bolts.
    2. Detach the bracket from the HCU.
      Fig 1: Identifying HCU Bracket
      G01947867Courtesy of FORD MOTOR CO.
  3. Remove the anti-lock brake control module.
    1. Remove the screws.
    2. Remove the anti-lock brake control module.
    Fig 2: Removing Anti-Lock Brake Control Module
    G01947868Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.