Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 39 (AUTOLAMP System)
WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
- Description
- Adjustments
- Trouble Shooting
- Self-Diagnostics
- Diagnostic Trouble Code Tests
- DTC B1312: Headlight Input Circuit Shorted To Battery
- DTC B1317: Battery Voltage High
- DTC B1318: Battery Voltage Low
- DTC B1334: DECKLID Ajar Rear Door Short To Ground
- DTC B1342: Ecu Internal Failure
- DTC B1352: Ignition Key-In Circuit Failure
- DTC B1462: Seat Belt Switch Circuit Failure
- DTC B1464: Seat Belt Switch Short To Battery
- DTC B1483: Brake Pedal Input Circuit Failure
- DTC B1485: Brake Pedal Input Short To Battery
- DTC B1491: Ignition Cylinder Tamper Switch Circuit Failure
- DTC B1498: DECKLID Punch-Out Switch Short To Ground
- DTC B1501: Left Turn Signal Short To Battery
- DTC B1505: Right Turn Signal Short To Battery
- DTC B1509: Flash-To-Pass Short To Battery
- DTC B1515: Driver's Seat Occupied Switch Circuit Failure
- DTC B1522: Hood Switch Short To Ground
- DTC B1562: Door Lock Cylinder Short To Ground
- DTC B1566: Door Ajar Circuit Short To Ground
- DTC B1569: High Beam Switch Short To Battery
- DTC B1577: Park Light Switch Short To Battery
- DTC B1582: Panel Dim Increase Switch Short To Battery
- DTC B1586: Panel Dim Decrease Switch Short To Battery
- DTC B1590: AUTOLAMP Delay Increase Switch Short To Battery
- DTC B1594: AUTOLAMP Delay Decrease Switch Short To Battery
- DTC B1795: Low Beam Headlight Output Circuit Open
- DTC B1799: Front Turn Signal Output Circuit Open
- DTC B1803: Rear Turn/Stop Light Output Circuit Open
- DTC B1807: Taillight Output Circuit Open
- Symptom Tests
- Removal & Installation
- Wiring Diagram
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
