Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Symptom Tests: Notes
WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART
| Symptom | Symptom Test |
|---|---|
| No Module Communications | A |
| Headlights Inoperative | B |
| Headlights Always On | C |
| Autolamp Time Delay Inoperative | D |
| Autolamp Will Not Turn Off | D |
| Headlights Inoperative With Autolamps On | D |
| High Or Low Beams Inoperative | D |
| Autolamp Completely Inoperative | E |
| Battery Saver Does Not Time Out | F |
| Flash-To-Pass Inoperative | F |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
