1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 39 (AUTOLAMP System): Description: Notes

WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.

The autolamp system is a light-sensitive, on-off control. It will automatically turn the headlights on and off. The system can be set to automatically turn off interior and exterior lights after the ignition has been turned off. This feature is adjustable and has a maximum time delay setting of up to 3 minutes.

Autolamp system consists of the light sensor amplifier, located in the defroster grille on top left dash, Lighting Control Module (LCM), located underneath dash on right side of steering column and time delay switch which is integral with headlight switch.

Autolamp system LCM communicates with other control modules via module communications network.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.