Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996MUSTANG COBRA, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM
1996 Ford Mustang Cobra, 2D Convertible, Standard
Supplemental Inflatable Restraint System
1996 Ford Mustang Cobra, 2D Convertible, StandardSECTION Supplemental Inflatable Restraint System
- Identification
- Description & Operation
- Service Precautions
- Disabling & Activating Air Bag System
- Post-Collision Inspection
- Adjustments
- Disposal Procedures
- Removal & Installation
- System Operation Check
- Wire Repair
- Torque Specifications
- Diagnosis & Testing
- Diagnostic Tests
- On-Demand Self-Test
- DTC B1867 - Low Battery Voltage
- DTC B1913 - Air Bag Circuit Short To Ground
- DTC B1914 - Impact Sensor Shorted To Ground
- DTC B1921 - Diagnostic Monitor Not Mounted To Vehicle Properly
- DTC B1922 - SAFING Sensor Shorted To Battery Voltage
- DTC 1923 - Memory Clear Circuit Improperly Grounded
- DTC B1932 - High Resistance Or Open In Driver-Side Air Bag Circuit
- DTC B1933 - High Resistance Or Open In Passenger-Side Air Bag Circuit
- DTC B1934 - Low Resistance Or Short In Driver-Side Air Bag Circuit
- DTC B1935 - Low Resistance Or Short In Passenger-Side Air Bag Circuit
- DTC B1941 - Center/Right Impact Sensor Feed/Return Circuit Open
- DTC B1942 - Left Impact Sensor Feed/Return Circuit Open
- DTC B1944 - Center Impact Sensor Not Mounted To Vehicle Properly
- DTC 1945 - Left Impact Sensor Not Mounted To Vehicle Properly
- Wiring Diagram
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.