Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996CROWN VICTORIA POLICE INTERCEPTOR, 4.6 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANEL - ELECTRONIC
1996 Ford Crown Victoria Police Interceptor, 4.6 9
Instrument Panel - Electronic
1996 Ford Crown Victoria Police Interceptor, 4.6 9SECTION Instrument Panel - Electronic
- Description & Operation
- Testing
- Notes
- Self-Diagnostic Mode
- Pinpoint Tests
- Pinpoint Test A - Display Not Lit, Backlit But Blank Display Too Dim
- Pinpoint Test B - Display Scrambled, Segments Half Lit, Segments Blinking Or Missing, Display Incorrect, Display Stuck With All Segments On
- Pinpoint Test C - Display Does Not Respond To Buttons - No Beep Sound When Buttons Pressed, No Driver Alert Sounds
- Pinpoint Test D - Co Displayed, Gauge Blanks Out Fuel Tank Symbol, Lights 2 Top & 2 Bottom Bars Of Fuel Gauge
- Pinpoint Test E - Cs Displayed, Gauge Blanks Out Fuel Tank Symbol, Lights 2 Top & 2 Bottom Bars Of Fuel Gauge
- Pinpoint Test F - Inaccurate Fuel Indication
- Pinpoint Test G - Temp Gauge Displays 2 Top & 2 Bottom Bars
- Pinpoint Test H - Temp Gauge Always Indicates Hot Or Cold
- Pinpoint Test J - No Warning Tone When Therm Symbol Blinking
- Pinpoint Test K - Speedometer Indicates 0 Mph At All Speeds When Vehicle Is In Motion
- Pinpoint Test L - Speedometer Always Indicates Too High Or Too Low
- Pinpoint Test M - Speed Indication Varies Erratically
- Pinpoint Test N - Speed Control Indicator Is Always On
- Pinpoint Test P - Speed Control Indicator Does Not Come On
- Pinpoint Test Q - Odometer Displays "S" Message
- Pinpoint Test R - Mileage Always Indicates Too High Or Too Low
- Pinpoint Test S - Odometer Does Not Accumulate Mileage, Or Accumulates One Mile & Then Jumps Backward
- Pinpoint Test T - Instantaneous Or Average Fuel Economy Always Indicates 0 Miles/Gal Or 99 Miles/Gal
- Pinpoint Test U - Distance To Empty Does Not Go Below 200 Miles With Fuel Tank Empty, Or Distance To Empty Always Indicates Zero
- Pinpoint Test V - Door Ajar Warning Never/Always On
- Pinpoint Test W - Trunk Ajar Warning Never/Always On
- Pinpoint Test X - Charge System Warning Always On
- Pinpoint Test Y - Ride CNTRL/Air Suspension Warning Always On
- Pinpoint Test Aa - Low Washer Fluid Warning Never/Always On
- Pinpoint Test GG - Low Oil Pressure Warning Never/Always On
- Pinpoint Test KK - Trans CNTRL SELCTR INDICTR Never/Always On
- Removal & Installation
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.