System Tests: Notes

1996 Ford Crown Victoria Police Interceptor, 4.6 9SECTION Notes
SYMPTOM INDEX

Symptom Perform Test
The Powertrain Control Module Has A Fault On The Tan/Orange And/Or Pink/Light Blue Wire A 
Electronic Automatic Temperature Control Has A Fault On The Tan/Orange And/Or Pink/Light Blue Wire B 
Fault On Tan/Orange And/Or Pink/Light Blue Wire C 
The Fuel Indication Module (FIM) Has An Open Circuit On Tan/Orange And/Or Pink/Light Blue Wire D 
Fault On Tan/Orange And/Or Pink/Blue Wires (EATC Not Equipped) E 
Lighting Control Module Does Not Respond F 
The Anti-Lock Brake Module Does Not Respond G 
Driver Seat Module Does Not Respond H 
Driver Door Module Does Not Respond J 
Integrated Air Bag Monitor Does Not Respond K 
No Module Response L 
Lighting Control Module, Integrated Air Bag Monitor, Driver Door Module And Driver Seat Module Do Not Respond-Vehicles Not Equipped With Anti-Lock Brakes (ABS) M 
No Module Response (Vehicles Not Equipped With Driver Seat Module) N 
The Lighting Control Module, Integrated Air Bag Monitor And Driver Door Module Do Not Respond (Vehciles Not Equipped With Anti-Lock Brakes And Driver Seat Module) P 
The Lighting Control Module, Integrated Air Bag Monitor And Anti-Lock Brake Module Do Not Respond (Vehicles Not Equipped With Driver Door Module And Driver Seat Module Q 
The Lighting Control Module And Integrated Air Bag Monitor Do Not Respond (Vehicles Not Equipped With Anti-Lock Brakes, Driver Door Module And Driver Seat Module R 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.