Component Locations

1996 Ford Crown Victoria Police Interceptor, 4.6 9SECTION Component Locations
COMPONENT LOCATIONS

Component Location
Anti-Lock Brake Module (ABS) Under Battery Tray In Lower Left Engine Compartment
Driver's Door Module (DDM) In Driver's Door Behind Door Trim Panel
Driver's Seat Module Under Driver's Seat
Electronic Automatic Temperature Control Module (EATC) On Evaporator Case In Passenger Compartment On Passenger Side Of Vehicle
G101 Rear Of LH Front Fender Apron
Integrated Air Bag Module (IABM) Behind Instrument Panel, To Right Of Steering Column, As Far Up As Can Be Located
Lighting Control Module (LCM) Under Instrument Panel, To Right Of Steering Column
Powertrain Control Module (PCM) In Engine Compartment On Passenger Side Of Vehicle On Bulkhead
Fig 1: Identifying Component Locations
G00369021Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.