Disabling System

1994 Ford Aerostar Van Cargo Extended, 3.0 U, StandardSECTION Disabling System
NOTE: The following disabling procedure should be used for component replacement purposes only. If vehicle was involved in a collision and air bag did not deploy, or SRS is not functioning properly, complete system deactivation is required if vehicle needs to be driven. See COMPLETE SYSTEM DEACTIVATIONΒ  .

Disconnect negative and then positive battery cables. Shield both cables. Air bag system contains a back-up power supply built into the air bag diagnostic monitor. Wait a minimum of one minute before servicing any air bag system components. System is now disabled.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.