Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994AEROSTAR VAN CARGO EXTENDED, 3.0 U, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEM
1994 Ford Aerostar Van Cargo Extended, 3.0 U, Standard
Air Bag Restraint System
1994 Ford Aerostar Van Cargo Extended, 3.0 U, StandardSECTION Air Bag Restraint System
- Description & Operation
- Service Precautions
- Disabling & Activating Air Bag System
- Post-Collision Inspection
- Adjustments
- Disposal Procedures
- Removal & Installation
- Testing - System Operation Check
- Wire Repair
- Diagnosis
- Testing - Diagnostic
- Notes
- Test A - Air Bag Light Does Not Light, Inoperative Air Bag Light Circuit
- Test B - Air Bag Warning Light Stays On, Diagnostic Monitor Disconnected Or Faulty
- Code 12 - Loss Of Battery Power To Air Bag Firing Circuit
- Code 13 - Front Impact Sensor Or Air Bag Circuit Shorted To Ground
- Code 21 - SAFING Sensor Not Mounted To Vehicle Properly
- Code 22 - SAFING Sensor Shorted
- Code 23 - Open Circuit In SAFING Sensor Feed Circuit
- Code 24, SAFING Sensor Diagnostic Circuit Open Or Low Resistance In Front Impact Sensor
- Code 32 - High Resistance Or Open In Driver-Side Air Bag Circuit
- Code 33 - High Resistance Or Open In Passenger-Side Air Bag Circuit
- Code 34 - Low Resistance Or Short In Driver-Side Air Bag Circuit
- Code 35 - Low Resistance Or Short In Passenger-Side Air Bag Circuit
- Code 41 - High Resistance Or Open Front Impact Sensor Circuit
- Code 44 - Right Front Impact Sensor Not Mounted To Vehicle Properly
- Code 45 - Center Front Impact Sensor Not Mounted To Vehicle Properly
- Code 46 - Open Center Front Impact Sensor Circuit
- Code 51 - Diagnostic Monitor Internal Thermal Fuse Open
- Code 52 - Back-Up Power Supply Fault
- Code 53 - Diagnostic Monitor Internal Fault
- Rapid Flashing Of Air Bag Light, All Impact Sensors Disconnected
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.