SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992CROWN VICTORIA TOURING, AOD-EREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SYSTEM/COMPONENT TESTS - EEC-IVMODULES, RELAYS & SOLENOIDSFUEL PUMP RELAY
1992 Ford Crown Victoria Touring, AOD-E

Fuel Pump Relay

1992 Ford Crown Victoria Touring, AOD-ESECTION Fuel Pump Relay
NOTE: Fuel pump relay is located inside Integrated Relay Control Module (IRCM) on 2.3L, 3.0L & 3.8L. For IRCM test procedures, see CIRCUIT TEST X in TESTS W/CODES - EEC-IV article in the ENGINE PERFORMANCE section. For IRCM location on Sable and Taurus, see CONTROL UNITS in ELECTRICAL COMPONENT LOCATOR article in ELECTRICAL. On all others, see CONTROL UNITS in appropriate ELECTRICAL COMPONENT LOCATOR article in ELECTRICAL.

Remove relay from vehicle. Connect battery voltage to terminal "C". See Fig 1 . Ground terminal "D". Measure resistance between terminals "A" and "B". Resistance should be less than one ohm with power applied and greater than 10 k/ohms with power removed.

Fig 1: Fuel Pump Relay Terminal ID (1.9L, 4.6L & 5.0L)
G92D03806
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.