Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1996SUMMIT WAGON AWD, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSTESTINGCRUISE CONTROL SWITCH TESTSMAIN SWITCH
1996 Eagle Summit Wagon AWD, Automatic
Main Switch
1996 Eagle Summit Wagon AWD, AutomaticSECTION Main Switch
- When switch is moved to Neutral position, continuity should be present between terminals No. 4 and 6. See Figure . When switch is moved to ON position, continuity should be present between terminals No. 2, 4 and 6.
- Connect battery voltage to terminal No. 2 and ground terminal No. 6. Battery voltage should be present on terminal No. 4 when main switch is moved to ON position. Replace switch if it does not test correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.