Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 88 (6.4L - DTCS P2017 TO P2110)DTC TROUBLESHOOTINGP2017 INTAKE MANIFOLD RUNNER POSITION SENSOR CIRCUIT HIGHPOSSIBLE CAUSES
2024 Dodge and Ram Durango SRT Hellcat Plus
Possible Causes
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| (K237) SRV SENSE CIRCUIT SHORTED TO VOLTAGE |
| (K237) SRV SENSE CIRCUIT SHORTED TO THE (F342) FUSED ASD RELAY OUTPUT CIRCUIT |
| SHORT RUNNER VALVE |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to: PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.