Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
2024 Dodge and Ram 1500 TRXSECTION Diagnostic Test
WARNING: This page is about a different car, the 2023 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
NOTE:
This DTC will set if the Body Control Module (BCM) is not configured for Driver Assistance System Module (DASM).
- Turn the ignition on.
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- Record any Freeze Frame or Environmental Data related to the DTCs.
Is the DTC active?
Yes
- With the scan tool, perform a vehicle configuration routine.
- Verify that the DASM alignment is correct. Perform the DASM Alignment procedure.
- Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to DRIVER ASSISTANCE SYSTEM MODULE DASM VERIFICATION TEST .
No
- No repair is necessary. Clear the DTC and verify proper operation of the DASM.
- Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to DRIVER ASSISTANCE SYSTEM MODULE DASM VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.