Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 VAN CARGO EXTENDEDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCOOLING SYSTEMENGINEHEATER, ENGINE BLOCKINSTALLATION
2023 Dodge and Ram ProMaster 3500 Van Cargo Extended
Heater, Engine Block: Installation
2023 Dodge and Ram ProMaster 3500 Van Cargo ExtendedSECTION Installation
- Thoroughly clean the cylinder block heater cavity and seat.
- Install the engine block heater (1) and tighten the engine block heater bolt (2) to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Attach the power cord plug to the engine block heater.
- Fill the cooling system to the proper level. Refer to COOLANT SYSTEM AIR EVACUATION .
- Install the generator. Refer to GENERATOR, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.