Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rod, Piston And Connecting: Removal
If the engine encounters a catastrophic failure, the engine oil cooler and lines must be replaced or damage to the new engine or components could result.
- Remove the cylinder head(s). Refer to CYLINDER HEAD, REMOVAL .
- Remove the oil pan. Refer to PAN, OIL, REMOVAL .
- If necessary, remove the ridge on top of the cylinder bores with a reliable ridge reamer before removing pistons from engine block. Be sure to keep the tops of the pistons covered during this operation. CAUTION:
When removing and installing the pistons and connecting rods, do not damage the piston oil cooler jets. If the jets are bent, engine damage may occur.
- Remove the piston oil cooler jet(s) retaining bolt(s) (2) and remove the piston oil cooler jet(s) (1).CAUTION:
Do not use a number stamp or a punch to mark connecting rods or caps, as damage to connecting rods could occur.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.