Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHARGER SXT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (6.4L ENGINE (SERVICE INFORMATION))VALVE TIMINGTENSIONER, ENGINE TIMINGINSTALLATION
2023 Dodge and Ram Charger SXT, 4WD
TENSIONER, Engine Timing: Installation
2023 Dodge and Ram Charger SXT, 4WDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
This is a Zero-Tolerance engine. Failure to properly align the timing chain to the timing gears will cause severe engine damage. It is imperative that the Timing Marks shown in the subsequent steps be properly aligned during assembly.
|
8 |
- Install the timing chain tensioner. Tighten the bolts (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Remove the Tensioner Pin (special tool #8514A, Pins, Tensioner) (2).
- Remove the zip tie from the timing chain guide.
- Install the timing cover. Refer to COVER(S), ENGINE TIMING, INSTALLATION .
- Remove the dial indicator from cylinder No. 1 and install the spark plugs. Refer to SPARK PLUG, INSTALLATION .
- Connect the negative battery cable.
- Start the engine and inspect for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.