Cover(S), Engine Timing: Removal

2023 Dodge and Ram Charger SXT, 4WDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Remove the throttle body. Refer to THROTTLE BODY, REMOVAL .
  2. Remove the water pump. Refer to PUMP, WATER, REMOVAL .
    GC0148461Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the camshaft position sensor wire harness connector (1).
  4. Remove A/C compressor from the front timing chain cover and position aside. Refer to COMPRESSOR, A/C, REMOVAL .
  5. Remove the generator from the front timing chain cover and position aside. Refer to GENERATOR, REMOVAL .
  6. Remove the vibration damper. Refer to DAMPER, VIBRATION, REMOVALΒ .
    GC0184543Courtesy of CHRYSLER GROUP, LLC
  7. Remove the five front oil pan to timing cover bolts (1).
    GC0184512Courtesy of CHRYSLER GROUP, LLC
  8. Remove the engine timing cover retaining bolts (1) and remove the engine timing cover.
    GC0081832Courtesy of CHRYSLER GROUP, LLC
  9. Verify that the engine timing cover slide bushings (1) remain located in the engine timing cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.