Manifold, Intake: Removal

2023 Dodge and Ram Charger SXT, 4WDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Perform the fuel system pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  2. Disconnect and isolate the negative battery cable.
    GC0148445Courtesy of CHRYSLER GROUP, LLC
  3. Remove the engine covers (1).
  4. Disconnect the fuel supply line. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .
  5. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVALΒ .
  6. Disconnect the brake booster hose and the vapor purge hose.
    GC0148454Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the wire harness connectors from the following components:
    • Manifold Absolute Pressure (MAP) Sensor
    • Short Runner Valve (SRV)
    • Fuel Injectors
    • Electronic Throttle Control (ETC)
  8. Using the sequence shown in the illustration, remove the intake manifold retaining bolts.
  9. Remove the intake manifold and throttle body as an assembly from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.