Fuel System Pressure Release

2023 Dodge and Ram Charger SXT, 4WDSECTION Fuel System Pressure Release
WARNING:

The fuel system is under constant high pressure even with engine off. Until the fuel pressure has been properly released from the system, do not attempt to open the fuel system. Do not smoke or use open flames/sparks when servicing the fuel system. Wear protective clothing and eye protection. Make sure the area in which the vehicle is being serviced is in a well ventilated area and free of flames/sparks. Failure to comply may result in serious or fatal injury.

  1. Remove the fuel pump relay from the Power Distribution Center (PDC). Refer to FUSE - RELAY LOCATIONS AND TYPES, SPECIFICATIONS . A relay location label can also be found on the underside of the PDC cover.
  2. Start and run the engine until it stalls.
  3. Attempt restarting engine until it will no longer run.
  4. Turn the ignition to the OFF position.
  5. Return fuel pump relay to the Power Distribution Center (PDC).
NOTE:

After servicing the fuel system, one or more Diagnostic Trouble Codes (DTCs) may have been stored in the Powertrain Control Module (PCM) memory due to disconnecting the fuel pump module circuit. A diagnostic scan tool must be used to erase a DTC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.