Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHALLENGER SXT, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, INTEGRATED CENTER STACK (ICSM)INSTALLATION
2023 Dodge and Ram Challenger SXT, RWD
Module, Integrated Center Stack (ICSM): Installation
2023 Dodge and Ram Challenger SXT, RWDSECTION Installation
- Position the Integrated Center Stack (ICS) (1) to the shifter bezel panel and install the four screws (2).
- Connect the wire harness connectors and install the shifter bezel panel (1).
- For automatic shifter, install the shifter knob and install the screw (4). Tighten the screw securely.
- Connect the wire harness connector (3).
- Position the shifter bezel (2) and engage the retaining clips.
- For manual shifter, install the shift lever (2) and the bolts (3). Tighten the shift lever bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS, 6.2L or TORQUE SPECIFICATIONS, 5.7L & 6.4L .
- Position the shifter boot (1) and engage the retaining clips.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.